Author Topic: Carburetor - UPDATE  (Read 881 times)

0 Members and 1 Guest are viewing this topic.

ernie

  • Newbie
  • *
  • Posts: 6
    • View Profile
    • Email
Carburetor - UPDATE
« on: July 18, 2015, 06:02:15 AM »
I found machining the V-Twin carbonator quite challenging and one of the more difficult parts to make next to the gear case. So much that it took me three tries to get it right. In my opinion, the original drawing is just too confusing and that lead to the errors in machining the part. As a result I redrew the carbonator body using conventional drawing and dimensioning practices. If you would like the drawing send me an SASE and I will gladly send it to you, but ONLY if you purchased the V-Twin drawing set from Howell. Email me --- ernie7@bellsouth.net

« Last Edit: August 07, 2015, 04:47:07 AM by ernie »