Author Topic: Mini-Drill Quill Feed Shaft Gear diameter missing  (Read 2954 times)

0 Members and 1 Guest are viewing this topic.


  • Administrator
  • Sr. Member
  • *****
  • Posts: 253
    • View Profile
    • Email
Mini-Drill Quill Feed Shaft Gear diameter missing
« on: December 27, 2011, 05:53:01 PM »
Here's an e-mail I received from Don Holloway on Dec 27, 2011:


I purchased plans for the precision mini drill press a while back and want to start to build soon.
The only thing that I don't see is the OD for the quill feed shaft gear.
Do you know what the OD of the gear should be?

Thanks and the best to you folks in the new year.


My reply:


Good question.  Nobody has asked me that before, and I did not realize it was missing.  Unfortunately, Dad passed away over two years ago so I can't ask him, and his prototype does not have this gear exposed for me to measure it.

Would the pitch and angle of the gear teeth determine the diameter?  I'm not a machinist, so maybe I'm all wet in that theory.

I will post your question on our user forum - perhaps some other builders will be able to assist.  If not, I guess hold off on this part as long as possible, then perhaps the diameter can be surmised by the distance from it's shaft and the position of the quill - ???



If anyone can help answer this more definitively, it would be appreciated!



  • Newbie
  • *
  • Posts: 2
    • View Profile
    • Email
Re: Mini-Drill Quill Feed Shaft Gear diameter missing
« Reply #1 on: December 27, 2011, 07:04:10 PM »
 The OD of a gear is a formula which is #teeth plus 2 divided by the DP or  20+2/24= .916